» Mot-clé : TYTERA

TYT TH-UV8000D frequency bands mod

I'll probably update this procedure with a nice PDF document, as usual, but for now you'll have to settle for this.
UPDATE: You can now edit the codeplug with a hex editor and keep all your presets (config & channels).
UPDATE 2: I've performed a very quick TX/RX test on the 200MHz band with a R&S radio service monitor. Jump to the end of this article to learn more.
UPDATE 3: The PDF is available at the end of this entry.

Lire la suite...

SMA to FME adapter 3D printed strengthening piece

USC230BrokenBnc.jpgIf you haven't broken your handled transceiver's antenna connector when using a long antenna yet, this will certainly happen sooner or later.
I've faced this problem with my USC230 a year ago, and I didn't want it to happen again on my TYT MD380. Furthermore, the MD380's SMA is a lot more fragile than the USC230's BNC.
So, I've designed a small tube that holds the SMA to FME adapter on the inside, and that provides wide contact area on both ends: my Procom FSP70's antenna base and the MD380's SMA socket.
It just took me less than 2 hours from scratch to draw and print that little strengthening piece. Click "Read more..." to see the result and the gcode file download link:

Lire la suite...

Helping the TYT MD380 charger go green.

GreenEnergy.png If you came here hoping to charge your MD380 faster, you just fell into a trap!
By the way, you can still read the few following lines as this may still interest you .

Lire la suite...